UPGRADE SMART MICRO CONCRETE

• Ready-to-use formulation requiring only water addition.
• Excellent flow characteristics for easy placement.
• Rapid strength gain with high ultimate strength.
• Non-shrink and shrinkage-compensated performance.
• Resistant to impact and vibration.

• Grouting machine foundations and base plates.
• Grouting bearings and structural supports.
• Column joint grouting in precast construction.
• Anchoring bolts and reinforcement in concrete.
• Filling cavities, gaps, and voids in concrete structures.

• Product Type: Cementitious Non-Shrink Micro Concrete
• Appearance: Grey Powder
• Chemical Base: Portland Cement, Selected Fillers, Aggregates, and Special Additives
• Bulk Density @ 25°C: 1.30 – 1.40 kg/L
• Mixing Ratio: Water : Powder = 0.14 – 0.16 by Weight
• Water Requirement: 3.2 – 4.2 Litres per 20 kg Bag
• Pot Life at 30°C: Approximately 20 Minutes
• Consumption: Approximately 1900 kg/m³ of Concrete
• Minimum Layer Thickness: 25 mm per Pour
• Maximum Layer Thickness: 100 mm per Pour
• Shelf Life: 9 Months (in unopened packaging under recommended storage conditions)

Performance Properties

• Compressive Strength @ 24 Hours: 25 N/mm²
• Compressive Strength @ 7 Days: 45 N/mm²
• Compressive Strength @ 28 Days: 65 N/mm²
• Initial Expansion through Gas Generation
• Non-Corrosive
• Non-Flammable
• Non-Toxic
• Shrinkage Compensated

Step 1: Ensure the substrate is clean, sound, and free from dust, grease, oil, loose particles, and contaminants.

Step 2: Measure the required quantity of clean water according to the recommended mixing ratio of 0.14–0.16 water to powder by weight.

Step 3: Pour approximately 80–90% of the required water into a clean mixing container.

Step 4: Gradually add UPGRADE SMART MICRO CONCRETE powder while mixing mechanically using a low-speed mixer (maximum 500 RPM).

Step 5: Add the remaining water and continue mixing until a smooth, homogeneous, and flowable consistency is achieved.

Step 6: Adjust the consistency if required by carefully controlling the water content within the recommended limits.

Step 7: Pour the mixed micro concrete into the prepared formwork, cavity, foundation, or repair area and allow it to flow freely into place.

Step 8: Complete placement within the product's pot life of approximately 20 minutes and allow proper curing for optimum strength development. Do not add extra water after mixing.

 

Upgrade Enterprises Private Limited
Plot Nos. SA-31, 32, 40 & 41,
Cuncolim Industrial Estate,
Cuncolim, Salcete, South Goa,
Goa – 403703, India.